Hi DWB -
Need to check a couple of details:
1. Is this cDOT or 7-mode? Based on the original post and discussion of LIFs and home-node I assumed cDot, as those are cDot style terms, but with the information you added I have enough to question and I just want to confirm.
2. Can you relay the command you tried to use for the migrate? The reason I ask is that I think you've confused some information. The error message implies that you used the "port" name of a0a-25 as the name of a LIF on vServer filer_fs01 as opposed to the LIF name.
Key information : Ports (such as a0a-25) are associated with nodes (technically a type of SVM/vServer, but not really the same as a "data" SVM vServer). LIFs are associated with user created "data" SVMs. Again generalizing, as "intercluster LIFs" for replication are associated to the "cluster" SVM, which again technically an SVM but not a "data" SVM. It gets a bit confusing if you're not familiar with it.
Output that would be good to have:
set -rows 0
network port show
network interface show
The first command turns off the pagination on output. The second lists the ports by node. The third lists the LIFs by SVM. This way we can be sure ports are defined where expected and LIFs are known as we check out the exact form of the commands.
Hope this helps.
Bob Greenwald
Senior Systems Engineer | cStor
NCIE SAN ONTAP, Data Protection
Kudos and accepted solutions are always appreciated.
